Which of the following commands enables the IPv6 protocol on a router?

Start networking and exchanging professional insights

Next Question:
Config Static routing with example ?
Posted by:
Harsud hanath
28-February-2018

A. Router(config)#ipv6 unicast-routing B. Router(config)#ipv6 enable C. Router(config)#enable ipv6 D. Router(config)#ipv6 E. Router(config)#router ipv6

Networking Concepts CCNA

Question added by TARIQ MUHAMMAD ISMAIL MEMON , IT Team Leader , Saudi National Bank (Microland)
Date Posted: 2013/12/05

Upvote (1) Views (21) Followers (6) Answers (17) Report Question

Write an Answer
Register now or log in to answer.

17 Answers

by Ahamed Ameen , IT Infrastructure Manager , Abana Enterprises Group of Company

to enable the IPv6 in a router you need to enter "Router(config)#ipv6 unicast-routing" in global configuration mode.

Upvote (2)

Downvote Reply () Report

by Mostafa Mohamed Mostafa Hafez , Projects HSE Manager , DAR

Upvote (1)

Downvote Reply () Report

by Deleted user

Router(config)#ipv6 unicast-routing

Upvote (1)

Downvote Reply () Report

by JAYENDRA PARMAR , Support Engineers , Dunia finance LLC

Router(config)# ipv6 unicast-routing... This command is using very first time when configuring IPV6 protocol on a router..

Upvote (1)

Downvote Reply () Report

by Nkemdirichi Maduadugwo , Facility Manager , WLL

Upvote (0)

Downvote Reply () Report

by Noman Abdul Hadi Memon , IT Specialist , Wael Fouad Jamjoom Co. For Umrah

A Is The Correct Answer Brother Tariq ..

Upvote (0)

Downvote Reply () Report

by Mohammad Zahirul Islam , IT Manager , Windy Group

A is the correct ans.

Upvote (0)

Downvote Reply () Report

by Muhammad Yuseef , IT Manager , Master Point Trading

A is the correct answer

Router(config)#ipv6 unicast-routing

Upvote (0)

Downvote Reply () Report

by MOHD YASIR , Solution Architect Support , Tech Mahindra ltd

A. Router(config)#ipv6 unicast-routing this commond is change the mode of router ipv4 to ipv6

Upvote (0)

Downvote Reply () Report

by Syed Javed , it consultant , Infosys

To use feature of IPv6, you need to enable it by IPv6 unicast-routing command in global config mode.

Upvote (0)

Downvote Reply () Report

by RAVI TEJA K.V.

By default, IPv6 traffic-forwarding is disabled on a Cisco router. It must to be activated between interfaces by using the global configuration command - ipv6 unicast-routing . The global configuration command must be used in both Stateful (DHCPv6) and Stateless auto configuration. There are two basic steps used to activate IPv6 on a Cisco router: i.First, you must activate IPv6 traffic-forwarding on the router, and ii.then you must configure each interface that requires IPv6.

Upvote (0)

Downvote Reply () Report