What is the command syntax to configure port-security on a switch?

Start networking and exchanging professional insights

Register now or log in to join your professional community.

Next Question:
What is the command syntax to put a switch port in L2 or L3 mode?
Posted by:
Micheal Egereugwu
23-July-2017

802.1x Syntax Security

Question added by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER
Date Posted: 2017/08/17

Upvote (0) Views (2) Followers (1) Answers (1) Report Question

Write an Answer
Register now or log in to answer.

1 Answers

Micheal Egereugwu

by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER

sw(config)#switchport port-security

swConfig)#end

Downvote Reply () Report

Popular Searches

Sales Executive Jobs Engineers Jobs Engineering Technicians Jobs Accountant Jobs Driver Jobs

Write Your Answer

More Questions Like This

What is the command syntax for configuring a switch port for LAP?
Top Answer: sw#conf t sw(config)#vlan 100 sw(config-vlan)#name bayt-LAP sw(config-vlan)#exit sw(config)#int gig 1/0/0 ... See More

Answers (1)
What is the command syntax to disable POE on a switch port?
Top Answer: sw(config-if)#power inline never verification:sw# shpower inline {type mod/no} See More

Answers (1)
What is a switched virtual interface SVI as related to MLS and what is the command syntax to configure this?
Top Answer: SVI is a logical interface that is assigned a network layer 3 address and represents an entire vlan to co ... See More

Answers (1)
What is qos. what is the command syntax to configure a trust boundary between an ip phone and a switch?
Top Answer: qos is the overall method used in a network to protect and prioritize time-critical or important traffic. ... See More

Answers (1)

Do you need help in adding the right keywords to your CV? Let our CV writing experts help you.