What is the command syntax to put a switch port in L2 or L3 mode?

Question added by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER
Date Posted: 2017/07/23

Upvote (0) Views (0) Followers (1) Answers (1) Report Question

by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER

L2 MODE

L2(CONFIG)#INT TYPE MOD/NO

SW(CONFIG-IF)#SWITCHPORT

SW(CONFIG-IF)#IP IP ADDRESS IP-ADDRESS-MASK

FOR L3

SW(CONFIG)#INT TYPE MOD/NO

SW(CONFIG-IF)#NO SWITCHPORT

SW(CONFIG-IF)#IP IP ADDRESS IP-ADDRESS-MASK

VERIFY: SH INT TYPE MOD/NO SWITCHPORT

What is the command syntax to disable POE on a switch port?
Top Answer: sw(config-if)#power inline never verification:sw# shpower inline {type mod/no} See More

Answers (1)
What is the command syntax to configure port-security on a switch?
Top Answer: sw(config)#switchport port-security swConfig)#end See More

Answers (1)
What are the differences between L2,L3 and L4 Switches ?
Top Answer: Its Very Simple, L2 switches forwards the MAC address with low latency and L3 switch forwards IP address ... See More

Answers (1)
What is the command syntax to make a switch attempt to become the primary root bridge?
Top Answer: SW(config)# spanning-tree vlan vlan-no root{primary/secondary}*{diameter diameter} See More

Answers (1)

Do you need help in adding the right keywords to your CV? Let our CV writing experts help you.