What is a Transit area as regards to OSPF virtual links? What is the command syntax to configure OSPF virtual links?

Question added by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER
Date Posted: 2017/07/13

Upvote (0) Views (1) Followers (1) Answers (1) Report Question

by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER

Transit area is an area through which you configure a virtual link to connect to the back bone area through a non back bone area area.

SW(config)# area area-no virtual-link R-ID

What is the command syntax for configuring a switch port for LAP?
Top Answer: sw#conf t sw(config)#vlan 100 sw(config-vlan)#name bayt-LAP sw(config-vlan)#exit sw(config)#int gig 1/0/0 ... See More

Answers (1)
What is the command syntax for configuring HSRP md5 authentication?
Top Answer: sw(config)#key key-no sw(config-key-chain)#key-string[0/7] string sw(config)#exit sw(config)#int type mod ... See More

Answers (1)
What is qos. what is the command syntax to configure a trust boundary between an ip phone and a switch?
Top Answer: qos is the overall method used in a network to protect and prioritize time-critical or important traffic. ... See More

Answers (1)
What is the command syntax for voice vlan configuration?
Top Answer: Switch# configure terminal Switch(config)# interface gigabitethernet0/1 Switch(config-if)# mls qos trust ... See More

Answers (3)

Do you need help in adding the right keywords to your CV? Let our CV writing experts help you.