Register now or log in to join your professional community.
spanning tree portfast gets immediately comes up.
commad is sw1(config-if)#spanning-tree portfast.
Enable the command spanning-tree portfast
After a port on the switch has linked and joined the bridge group, STP runs on that port. A port that runs STP can be in one of five states:
blocking
listening
learning
forwarding
disabled
STP dictates that the port starts out blocking, and then immediately moves through the listening and learningphases. By default, the port spends approximately seconds listening and seconds learning
*Never use the PortFast feature on switch ports that connect to other switches, hubs, or routers. These connections can cause physical loops.
By adding the command "spanning-tree portfast" under the interface mode.. This feature is only enabled on switch ports that are facing hosts only.
On the interface port enable the "Spanning Tree portfast" command
Do you need help in adding the right keywords to your CV? Let our CV writing experts help you.
